Fanless and Silent

Passive cooling, no fan noise at all

Perfect to be used in noise-sensitive environments

Fanless, dust-free and thus virtually maintenance-free

 

Low Power Consumption

Power consumption in idle mode: 10~12 W (depends on peripherals)

Power consumption under full load: 17 W / 25.5 W (CPU / CPU+graphics)

(measured with 2x 4 GB DDR3L-1600 SO-DIMMs and 500 GB 2.5" hard disk under Windows 10 64-bit)

 

24/7 Nonstop Operation

This device is approved for 24/7 permanent operation.

Requirements:

- Free circulation of air amongst the PC must be guaranteed.

- Ventilation holes must stay clear.

- If a hard disk is installed, this must also be approved for permanent operation by its manufacturer

 

Chassis

Slim-PC (Nettop) with black chassis made of steel

Without cooling fan, passive cooling only

The bays for memory, 2.5" drive and M.2 card

can be easily accessed by removing two cover plates.

Dimensions: 200 x 165 x 39.5 mm (LWH) = 1.3 litres

Weight: 1.43 kg net and 2.13 kg gross

Two holes for Kensington Lock and numerous

threaded holes (M3) at both sides of the chassis

 

Operation Position

1) Vertical: Usually operated in vertical position with the supplied feet (DisplayPort output facing up).

2) VESA-mounted: The device can also be mounted behind an appropriate monitor using the supplied VESA mount kit.

Note: From a thermal point of view horizontal operation is permitted, however, there are no rubber feet on the device. The maximum operating temperature is 35°C then.

Operation System

This barebone system comes without operating system.

It is compatible with Windows 10, Windows 8.1, Windows 7 and Linux

Supports 64-bit operating systems

 

Processor

Model: Intel Celeron 3855U (ULV)

System-on-a-chip architecture (SoC): no chipset required

BGA1356 package - directly soldered onto the mainboard

Code name: Skylake-U (6th Generation Intel Core)

Cores / Threads: 2 / 2

Clock rate: 1.6 GHz

L1/L2/L3 Cache: 128 kB / 512 kB / 2048 kB

Memory controller: DDR3L-1600 Dual Channel (1.35V)

TDP wattage: 15 W maximum

Manufacturing process: 14 nm

Maximum Tjunction Temperature: 100°C

Supports 64-bit, VT-x (EPT), VT-d, Enhanced SpeedStep, NX bit, AES-NI, SSE 4.1/4.2

Integrated graphics engine

 

Integrated Graphics

Intel HD graphics 510 (Intel HD Gen. 9)

Two digital audio/video ports support two independent screens:

1) DisplayPort 1.2 [7] supports 4096x2304 @ 60Hz

2) HDMI 1.4 supports 4096x2304 @ 24Hz

Supports Ultra HD / 4K resolution

GPU clock rate: 300~900 MHz

Execution Units (EU): 12

Supports DirectX 12, OpenGL 4.4

Supports full h264, h265 8/10 bit, VP8/9, VC-1, AVC hardware decoding

Supports Quick Sync Video and Clear Video HD technology

Supports HD video plus multi-channel digital audio via a single cable

Dynamic, shared memory: up to 1.7 GB

 

Mainboard / BIOS

Shuttle Mainboard FS67

All capacitors are high quality solid capacitors

Supports resume after power failure

Supports Wake on LAN (WOL)

Supports Power on by RTC Alarm

Supports boot from M.2 SSD cards, USB devices and SD card reader

AMI BIOS in 8 MByte EEPROM with SPI interface

Supports hardware monitoring and watch dog function

Supports Unified Extensible Firmware Interface (UEFI)

 

Power Adapter

External 65 W power adapter (fanless)

Input: 100~240 V AC, 50/60 Hz, max. 1.6 A

Output: 19 V DC, max. 3.42 A, max. 65 W

DC Connector: 5.5/2.5mm (outer/inner diameter)

 

Memory support

2x SO-DIMM slots with 204 pins

Supports DDR3L-1600 (PC3-12800) SDRAM at 1.35V

Supports Dual Channel mode

Supports a maximum of 16 GB per DIMM, maximum total size: 32 GB

Supports two unbuffered DIMM modules (no ECC or registered)

Caution: This mainboard does only support 1.35V DDR3L memory modules.

DDR3L has a lower operation voltage compared to DDR3

 

Audio

Audio Realtek® ALC 662 High-Definition Audio

Two analog audio connectors (3.5mm) at the back panel:

1) 2 channel line out (headphones)

2) microphone input

Digital multi-channel audio output: via HDMI and DisplayPort

 

Dual Gigabit LAN

Dual network with two RJ45 ports

Used network chips:

1) Intel i211 Ethernet Controller with MAC, PHY and PCIe interface

2) Intel i219LM PHY connected to the MAC of the processor

Supports 10 / 100 / 1.000 MBit/s operation

Supports WAKE ON LAN (WOL)

Supports network boot by Preboot eXecution Environment (PXE)

Supports Teaming mode

 

Wireless Network (WLAN)

WLAN expansion card (M.2-2230-AE) with two external antennas

One antenna for WLAN, the second antenna is for Bluetooth (supplied)

Chip: Realtek RTL8821AE

Supports Wireless LAN IEEE 802.11b/g/n/ac 1T1R, 2,4 GHz or 5 GHz

Max. speed: 150 Mbps (2.4 GHz) or 433 Mbps (5 GHz)

Supports Bluetooth 4.0

 

M.2 Slot for SSDs

The M.2 2242 BM slot provides the following interfaces:

- PCI-Express Gen. 2.0 X4 with up to 16 Gbps Data Transfer Speed

- SATA v3.0 (max. 6 Gbps)

It supports M.2 cards with a width of 22 mm and a length of 42 mm (type 2242)

Supports M.2 SATA SSDs (with B+M key) and M.2 PCIe SSDs (with M key)

 

2.5" Drive Bay with SATA connector

Supports one Serial ATA hard disk

or one SATA SSD drive in 6.35cm/2.5" format

Device height: 9.5 or 12.5 mm (max.)

Supports Serial-ATA III, 6 Gb/s (600 MB/s) bandwidth

Supports Unified Extensible Firmware Interface (UEFI)

Note: no Serial ATA cable is required

 

Card Reader

Integrated SD card reader

Supports SD, SDHC and SDXC memory flash cards

Supports booting from SD card

 

Front Panel connectors

2x USB 3.0

2x USB 2.0

2x RS232 serial ports (5V/12V, 1x switchable to RS422 / RS485)

covered with black plastic caps

SD card reader (supports SD, SDHC, SDXC)

Power button

Power LED (blue)

HDD LED (yellow)

 

Back Panel connectors

DisplayPort 1.2

HDMI 1.4

2x USB 2.0

2x Gigabit LAN (RJ45)

Microphone input

Audio Line-out (headphones)

DC-input connector for external power adapter

4-pin connector "SW2" (2.54 mm pitch) for power button, Clear CMOS and 5V DC

2x RP-SMA connectors for external Wireless LAN antennas (antennas are supplied)

 

Always-On Jumper

By removing Jumper J9 (please refer to the quick user guide)

the system will start unconditionally once power is applied.

 

Scope of Delivery

Multi-language user guide

Two metal feet with four screws M3 x 7

VESA mount for 75/100mm standard (two metal brackets)

Four thumbscrews M3 x 5 mm (screws together VESA mount and PC)

Four screws M4 x 10 mm (to fix the VESA mount to the external surface)

Rack (to mount a 2.5" storage in the bay) with two screws M3 x 4 mm

Two antennas for WLAN and Bluetooth

Driver DVD for Windows 7, 8.1 and 10 (64-bit)

External power adapter with power cord

 

Environmental Specifications

Operating temperature range: 0~40 °C

Relative humidity, non-condensing: 10~90%

 

Conformity/Certifications

EMI: FCC, CE, BSMI, C-Tick

Safety: ETL, CB, BSMI

Other: RoHS, Energy Star, ErP

This device is classed as a technical information equipment (ITE) in class B and is intended for use in living room and office. The CE-mark approves the conformity by the EU directives:

(1) 2004/108/EC relating to electromagnetic compatibility (EMC),

(2) 2006/95/EC relating to Electrical Equipment designed for use within certain voltage limits (LVD),

(3) 2009/125/EC relating to ecodesign requirements for energy-related products (ErP),

(4) 1999/5/EC related to Radio and Telecommunications Terminal Equipment (R&TTE)